FAQs Frequently Asked Questions About our Products and Solutions

Ask a Question Ask a Question

All FAQs (1921 total: showing 201-220)

If the NR01-L is not listed as a sensor in Short Cut, how can the sensor be configured?
Can the NR01-L be used to measure the net radiation of artificial light?
Does the NR01-L need to be mounted on a separate tower to avoid the effect of radiation from other instruments?
Does the NR01-L need to be mounted above all the other instruments on a tower so that it has a clear view of the sky?
Can the CS616 or CS625 be measured with a 21X or CR7 datalogger?
Can the CS616 be used with CR200- or CR200X-series dataloggers?
When the soil becomes completely saturated, does the CS616/CS625 still provide accurate readings, or does it display “NAN”?
How can the relative dielectric permittivity value be calculated from the available output of the CS616 or the CS625?
What might cause a CS616 or CS625 signal to keep reading -6999?
What might cause a “NAN” readout for a CS616 or CS625?
With the CS616 or CS625, what is the method for correcting for temperature fluctuations?
If a CS616 or CS625 is removed from one site and placed at another site, is there any resetting or recalibration that needs to be done?
If the rods on the CS616 or CS625 get bent, can they be bent back to parallel again without negatively affecting future measurements?
Is it possible to cut the rods of the CS616 or the CS625?
Is there any temperature dependence in CS616 or CS625 measurements?
How many CS616 probes can be connected to a CR1000?
Can the CS616 or CS625 be connected to a multiplexer?
Can measurements from a CS616 be read by a non-Campbell Scientific data logger?
Can measurements from a CS625 be read by a non-Campbell Scientific data logger?
Can the CS625 be measured with a CR1000 datalogger?

Previous Next