All FAQs (1917 total: showing 341-360)
- Does the SR50A-L need a temperature probe?
- To use the CPEC200/310 scrub module as a source of zero gas, is it necessary for the CPEC200/310 system to include a valve module?
- Is there a calibration procedure for the PWS100?
- At a consistently windy site, is a PWS100 less accurate than a tipping bucket rain gage?
- How can a copy of the PWS100 Present Weather Viewing Software be obtained?
- What does the Present Weather Viewing Software do? For example, can it save data?
- Can a PWS100 be used to measure visibility? If so, can it be used in a sandy area such as the Sahara Desert?
- What is the current drain of the PWS100?
- How is the PWS100 different from a rain gage or snow depth sensor?
- Can an HFP01SC-L provide correct running averages if the scan rate is reduced to 1 minute?
- If Short Cut does not list the TCAV-L on its sensor list, what should be done?
- Is it OK to have a TCAV-L connected to a data logger using a very long cable (100 ft/30 m)?
- What are the measuring range, accuracy, and resolution of the TCAV-L?
- What is the temperature range of the TCAV-L?
- What might cause a 25% difference between the factory calibration and the in-situ calibration of an HFP01SC-L?
- What type of quality assurance/quality control can be performed on HFP01SC-L measurements?
- For the HFP01SC-L, is there an available acquisition program that is capable of running in PipeLineMode?
- If Short Cut does not list a heat flux plate on its sensor list, what should be done?
- Does the HFP01SC-L have to be in direct thermal contact with the surrounding soil to achieve heat flux readings?
- Can the HFP01SC-L be embedded in railroad ballast, which comprises a blend of coarse rock particles?
Previous
Next