Hi
I need to set up a connection between a Raven xt g2263-c Modem and a datalogger CR1000.
I'm new on this so i have followed the raven's manuals to communicate the modem to my computer's usb modem with not good result
1) I begin installing the raven's usb drivers on windows 7 but it can't find the drivers. I've tried downloading the drivers from sierra wireless support but the problem persist.
2) Anyway I try to communicate using AceManager but obviously an error appears it says :"PPPSocket: This program only supports port settings from 1200,8N1 to 115200,8N1. Please use SOS mode."
I would really apreciate any kind of information!
Try starting with section 5
https://s.campbellsci.com/documents/us/manuals/ravenxtg.pdf
Connect the RavenXTG to a COM port on the PC with a direct RS-232 cable.
Click the Connect icon in the Configuration Panel to open the connection options dialogue box.
Select PPP and choose the COM port the modem is connected to. Do not change the Password (the default password is 12345).
Click OK to continue.
If the modem has been configured for “PPP” (see Appendix C, Configuring the RavenXTG Modem for PPP), then you may have to check the “Use SOS Mode” box.
Depending on what you've done so far you might want to check out the Reset Button
The Reset button (on the left side of the RavenXTG) has two functions. If it is quickly depressed and released, the modem will simply power cycle the internal hardware. If, however, the reset is depressed and held for several seconds (count to 10 slowly and wait for the power light to go off
after the light pattern stops), the ALEOS configuration settings will return to the factory defaults.
I m having the same issue. Did you resolve it?