This product is not available for new orders. We recommend ordering: SDM8X50.
| Services Available | |
|---|---|
| Repair | Yes |
| Calibration | No |
| Free Support | Yes |
Overview
The SDMX50 is available in a very limited supply. The SDMX50 will be replaced by the SDM8X50.
The SDMX50 is one of three 50 ohm, coaxial, 8:1 multiplexers that can be used in a TDR100-based system. It consists of a surge-protected multiplexer circuit board mounted in a 10" x 12" x 5" environmental enclosure. The enclosure's backplate provides a strain-relief point for the coaxial cables. Cable ties and desiccant are included.
Images
Specifications
| Outside Dimensions | 40.4 x 29.2 x 17.5 cm (15.9 x 11.5 x 6.9 in.) with mounts |
| Inside Dimensions | 25.4 x 30.4 x 12.7 cm (10 x 12 x 5 in.) for enclosure |
| Weight | 4.4 kg (9.8 lb) |
Power Requirements |
|
| Input Power | 12 Vdc |
| Quiescent Current Drain | < 1 mA |
| Current Drain during Switching | ~ 90 mA (all multiplexers of the same level switch simultaneously for less than 1 s) |
Related Documents
FAQs for
Number of FAQs related to SDMX50: 6
Expand AllCollapse All
-
The clicking sounds come from mechanical relays making and breaking their contacts.
-
No. All SDMX50-series multiplexers in a TDR100 system may be connected to the same 12 V power supply.
-
These three multiplexers all use the same relay board, but the housing differs. The multiplexers are described side-by-side on page 2 of this brochure.
The most popular model is the SDMX50SP, followed by the SDMX50.
-
PC-TDR is a free download in the Downloads section of the PC-TDR web page..
-
In applications where TDR probes are used to measure soil water content, the maximum distance from the TDR probe back to the TDR100/TDR200 (even through one or more multiplexers) cannot exceed 15 m (50 ft) when using RG58 coaxial cable; the CS605-L, CS630-L, and CS640-L TDR probes have an RG58 cable. When using low-loss coaxial cable, the distance cannot exceed ≈25 m (80 ft); the CS610-L, CS635-L, and CS645-L TDR probes have a low-loss coaxial cable.
In slope stability and rock mass deformation applications, the maximum coaxial cable length should not exceed ≈1 mile (5,280 ft). The maximum combined length of all SDM cables in the system should not exceed ≈76 m (250 ft).