Tell the CR1000X what you need it to do.
Create a program and wire your sensors.
Short Cut is a simple way to generate a program and wiring diagram. CRBasic Editor lets you look under the hood.
Make sure to follow your wiring diagram.
CR1000X Support Resources
Downloads (2)
Product Manuals (4)
Videos & Tutorials (29)
- New CR1000X Datalogger (2:26)
- CR1000X Series Getting Started
- Datalogger Programming
- Connect Window Tutorial
- View Data Tutorial
- Collect Data Tutorial
- CR1000X Datalogger Getting Started | Overview (Part 1) (2:21)
- CR1000X Datalogger Getting Started | Communicate (Part 2) (6:08)
- CR1000X Datalogger Getting Started | Program (Part 3) (6:25)
- CR1000X Datalogger Getting Started | Data (Part 4) (4:05)
- Empezar CR1000X (Spanish) | Introduccion (Parte 1/4) (2:30)
- Empezar CR1000X (Spanish) | Comunicacion (Parte 2/4) (7:36)
- Empezar CR1000X (Spanish) | Programacion (Parte 3/4) (8:11)
- Empezar CR1000X (Spanish) | Envio de programa, Descarga y Monitorizacion de datos (Parte 4/4) (5:20)
- Sending an OS to a Local Datalogger (Part 1) (5:28)
- Sending an OS to a Remote Datalogger (Part 2) (5:10)
- Ethernet over USB (2:11)
- LoggerNet Software | Changing Variables (2:33)
- LoggerNet Software | Network Planner (4:04)
- Pipeline and Sequential Modes (10:04)
- Double-Precision Calculations (5:50)
- Toolbox for Installation and Maintenance (2:21)
- Power Budgeting (4:07)
- Certificates of Calibration (1:05)
- Multiplexer Programming with a CR1000 Datalogger (6:09)
- Wiring a Datalogger to a Multiplexer (7:18)
- LoggerLink Software | An Introduction (12:11)
- SDI-12 Sensors | Transparent Mode (7:13)
- SDI-12 Sensors | Watch or Sniffer Mode (3:25)
FAQs (5)
- In the event that the CR1000X becomes damaged and needs a new wiring panel, what should be done?
- Does the CR1000X have a Thermistor() instruction similar to the CR6?
- How does the power usage of the CR1000X compare to the power usage of the CR1000 or CR6?
- After the release of the CR1000X, will the CR1000 continue to be sold and supported?
- Can a program written for a CR1000 be used on a CR1000X?